Last week I posted this video of my 3D Printed FPV Quadcopter! What would you like to see next? Make it go faster? Make it even smaller?
New Video Tomorrow! 12pm EST I added FPV to the 3D printed quadcopter and flew it through an FPV gate. I also had a little incident and a LiPo melted most of the electronics. Should I rebuild it? Or make a smaller version other people can build?
What's the best brand/type of PLA??? And other materials too! I am going to be testing some out in an upcoming project so I'm looking for suggestions. Comment your favorite below!
New video tomorrow 12pm EST! May or may not be a 3D printed linear actuator. Any guesses on itโs max load?
I am a full-time aerospace engineer who can't stop doing projects in his free time. This channel shows my projects venturing into 3D printing, electronics, RC planes, cars, and more!