https://www.youtube.com/watch?v=qqaehhGYV_I
This video from Sears PartsDirect shows how to correctly maintain your electric water heater by regularly draining the tank to flush out sediment. Every year

https://www.thespruce.com/drain-an-electric-water-heater-4125791
Turn the valve counter-clockwise to release a few gallons of water into the bucket or hose for a partial flush. If you are doing a complete drain and are using a hose, let the tank drain until empty. When using a bucket for a full flush, you should use rubber gloves to avoid getting scalded. Fill the bucket and open and close the valve as many

https://www.homedepot.com/c/ah/how-to-drain-a-water-heater/9ba683603be9fa5395fab90137620284
Put a towel or shallow catch basin in front of the water heater to catch the water that runs out. Get a 3/4-inch valve prepared with a 4-inch pipe nipple. Open the new valve. Wrap the threads in thread seal tape. Use a pipe wrench to remove the old valve. Quickly replace the valve with the new one.

https://www.youtube.com/watch?v=cTPSoUKiKRs
Keep the hot water flowing with This Old House plumbing and heating expert Richard Trethewey and Kevin O'Connor. (See below for a shopping list and tools.)SU

https://www.thespruce.com/how-to-drain-a-water-heater-2719055
Perform a Quick Flush. Before you shut off the water, connect a garden hose to the drain valve and try and flush the water heater tank a bit while the water pressure is on. To do this, open the drain valve for a few seconds and then close it again. The pressure will blow out any sediment stuck in the valve and help the tank drain faster.

https://www.searspartsdirect.com/diy/article/how-to-drain-the-tank-on-an-electric-water-heater-video
First, shut off the electrical power to your water heater. This is extremely important because the heating elements can break if they turn on when the tank is empty. Next, connect a garden hose to your water heater drain valve. Use a heavy-duty hose that won't be damaged by hot water. Run the open end of the garden hose out into your yard to a

https://www.thisoldhouse.com/plumbing/21016872/draining-flushing-an-electric-water-heater
Open one or two hot water faucets in the house to prevent damage to your pipes. Open the drain valve and inspect the water for sediment. If the water is full of sediment or is not clear, refill the heater and drain it again. To stir up sediment that has settled on the bottom of the tank, turn the water shut off valve on and off a couple of times.

https://rotorootermobile.com/how-to-drain-electric-water-heater/
One crucial maintenance task for every electric water heater is draining the tank periodically. Draining your electric water heater not only helps remove sediment buildup but also ensures optimal performance and prolongs its lifespan. In this comprehensive guide, we will walk you through the step-by-step process of draining an electric water

https://www.wikihow.com/Drain-a-Water-Heater
Attach a hose to the drain valve at the bottom of the heater and run the hose into a bucket or out of the house. Then, turn on a hot water tap somewhere in your home. Open the drain valve to let the water in the tank drain completely. Then close the valve and disconnect the hose.

https://www.thespruce.com/repair-an-electric-water-heater-1824636
First, check the water heater's circuit breaker in the service panel to make sure it hasn't tripped. If the breaker has tripped off, rock it to the OFF position, and then back to ON. If the heater's breaker did not trip off, reset the high-temperature limit on the heater. To do so, turn off the power to the water heater in the service panel.

https://www.youtube.com/watch?v=vTdxtd4HBzg
Electric hot water heater maintenance draining and filling the tank. Watch as I drain and refill a 40 gallon Rheem electric hot water heater. Shut off power/

https://www.bobvila.com/articles/how-to-drain-a-water-heater/
STEP 2: Run your drain line. Run a garden hose from the water heater drain to the exterior of your home. If the tank sits below grade (say, in the basement), you'll likely need at least two

https://www.hotwater.com/info-center/water-heater-maintenance.html
Step 3 - Drain some water from the water heater. Shut off the incoming cold water. Attach a garden hose to the drain valve. Open the drain valve and let a few gallons of water drain from the water heater. Step 4 - Remove the Rod. Using an electric impact wrench, use a 1 1/16 deep well socket to remove the anode.

https://www.thisoldhouse.com/plumbing/21124362/how-to-maintain-an-electric-water-heater
Steps: When an electric water heater stops producing hot water, check the main electrical panel to ensure the breakers aren't tripped. Next, check the emergency cut-off switch on the thermostat. If the switch button is popped out, reset it by pressing it in. Test a heating element by first turning off the electricity to the water heater.

https://ajalberts.com/how-to-drain-electric-water-heater/
Head back to your electrical panel and turn the circuit or fuse back on to power the water heater tank. Wait for the water to fill back up in the tank before attempting to use any hot water. This should take about 20-30 minutes for a 40-gallon water tank and 30-40 minutes for an 80-gallon tank. Don't Forget About the Professionals. Draining

https://www.hgtv.com/how-to/home-improvement/how-to-drain-a-water-heater
1. Turn Off Water Supply. Turn off the cold water supply valve at the top of the water heater. 2. Turn Off the Water Heater. Turn the thermostat to the "pilot" setting (gas) or shut off the power at the breaker box (electric). Note: Electric water heaters must be turned off completely during flushing.

https://products.geappliances.com/appliance/gea-support-search-content?contentId=39723
Once the water heater is empty, with the drain valve open and garden hose attached to the drain valve, turn on the cold water supply. Allow several gallons to flush through the drain valve and hose to an open drain. Turn off the water supply and allow any water remaining in the tank to drain. Repeat steps 3 and 4 until the water runs clear.

https://www.thisoldhouse.com/plumbing/21016402/how-to-maintain-a-water-heater
Lift the valve's tab to let some water out, then let go. If water keeps flowing, drain the tank partway, unscrew the old valve with a pipe wrench, and install a new one. 2. Check the Anode Rod. Ryan Benyi. Put a hose to the tank's drain cock and let out a few gallons of water. Now fit a 1 1/16-inch socket onto the rod's hex head on top of

https://www.plumbtimesc.com/draining-water-heater-the-great-debate-do-you-need-to-and-when-should-you/
Let the water cool. Wait at least a few hours to minimize the risk of injury from the hot water. Attach a hose to the water heater drain valve. You can use your garden hose for this. Attach it to the valve at the bottom of the water heater drain pipe below the tank.

https://www.waterconnection.com/how-to-drain-a-water-heater/
Step 2: Allow the Water to Cool Down. The water in your hot water heater can be extremely hot, posing a risk of burns or scalding. Therefore, it's necessary to allow the water in the tank to cool down before you start the draining process. This cooling period can take a few hours, but it's a crucial safety step that shouldn't be skipped.

https://www.lowes.com/n/how-to/water-heater-maintenance
Step 1: Replace the Heating Element. To replace the top or bottom heating element, disconnect power to the unit and drain the water heater tank. Disconnect the wires from the element and loosen it using an element wrench. Unscrew the element and pull it straight out.

https://www.youtube.com/watch?v=VOeAKXdWV-o
This video shows you how to empty sediment buildup that accumulates an the bottom of the tank. I initially did this because the hot water was only lasting a

https://www.allstate.com/resources/home-insurance/how-to-drain-a-water-heater
Select a Product. Follow our comprehensive guide for draining and maintaining your gas water heater or electric water heater to help keep it working efficiently!

https://www.msn.com/en-us/weather/topstories/ask-angi-how-should-i-maintain-my-water-heater/ar-BB1iTtrS
Draining and flushing the water heater once a year plays a vital role in keeping it in good shape, by removing sediment buildup. It's possible to DIY this task, though it's going to take you the

https://www.homeserve.com/en-us/blogs/
Your Guide to Draining a Water Heater Jun 06, 2021 Over time, natural minerals can settle to the bottom of your water heater tank and reduce its efficiency, shorten its life and potentially lead to clogs.