Views : 1,484,820
Genre: Science & Technology
Date of upload: Oct 22, 2020 ^^
Rating : 4.961 (448/45,142 LTDR)
RYD date created : 2022-04-09T19:05:11.578793Z
See in json
Top Comments of this video!! :3
Anesthesiologists use a glass syringe when placing an epidural for regional anesthesia. The anesthetic for an epidural needs to go into a very specific space near the spinal cord called the epidural space. The anesthesiologist advances a needle into the back with a glass syringe on the needle. Each time that the needle is advanced, the anesthesiologist lightly presses on the plunger and releases it. Because of the low friction in the glass syringe the plunger readily springs back if the needle tip is not in the epidural space. As soon as the needle reaches the epidural space, the plunger goes all the way in with no spring-back. A plastic syringe doesn't work for this, because it has too much friction to respond the same way.
733 |
Years ago, i worked in a potato chip factory. There was a single machine that peeled the potatoes by tumbling them over a series of shafts which were surfaced with brush bristles. The bearings that supported those brush shafts needed a lot of maintenance and we were using food grade grease to lubricate them. The grease would get washed away by the water, abrasive potato rind and inevitable amount of dirt that was present.
I made the suggestion that we adapt the bushing type support bearing by injecting water into them. This virtually ended the maintenance cycle since there was no longer any contact and the water flowing through kept the new bearings clean.
26 |
There was a very interesting CPU cooler concept out a few years back called the Sandia Cooler, which used this air-bearing principle. They thought the barrier was thin enough to still be thermally conductive and you could spin a plate that acted like a heatsink and a fan in one piece, at low friction. Cool idea, and Thermaltake tried it out with their Engine 17 and 27 coolers. But they weren't as effective as hoped.
60 |
I am seriously impressed with the professionalism of this channel. The manner in which Steve presents scientific material without losing my interest is applaudable. It is as if he has taken several bite-sized appetizer clips and cleverly combined and edited them into a full course meal in a very satisfying way. The sweet spot is between being oversaturated with information and being deprived of details pertinent to grasp the context. That sweet spot of captivation is where this channel lives and why I subscribed. I think this is my new favorite channel
10 |
I've watched Tom Lipton for years now and it never ceases to amaze me just how skilled he really is. He's what I would consider to be a master of his craft, but he's too humble to admit it. And that happens to be another reason I like watching his content. You know he's extremely skilled and knowledgeable but he's in no way pretentious about it.
1 |
At 3:30 it was a not very subtle advertising for your brother's company: Injection Mould Industry
294 |
@SteveMould
3 years ago
Today I Learned From The Comments Section: I was wrong about how ice skating works (common misconception). Thanks for the correction @W410p. Here's an explainer: https://youtu.be/yjSf7Yh9UZc The sponsor is Blinkist: The first 100 people to go to blinkist.com/stevemould will get unlimited access for 1 week to try it out. You'll also get 25% off if you want full membership.
487 |