14:00

DIY EV Part 55 - Another addition to the Shelf of Shame!

20:11

DIY EV Part 54 - Tidying up the Low Voltage Junction Box.

31:32

DIY EV Part 53 - Installing the Heater and Cleaning the Hoses, on the inside???

18:42

DIY EV Part 52 - Testing the Replacement Cabin Heater.

35:10

DIY EV Part 51 - Fixing Some of the Bits I Broke!!!

31:46

DIY EV Part 50 - Steering a new course with a Volvo PAS Pump

22:50

DIY EV Part 49 - Installing an Android Head Unit in a Freelander EV

04:15

DIY EV Part 48 - Driving to the MOT Centre.

33:14

DIY EV Part 47 - Getting it ready for MOT and First Drive on the Road 😃

28:55

DIY EV Part 46 - Open heart surgery on the Inverter 😮

19:12

Bob and Brad Q2 Mini Massage Gun review

27:19

DIY EV Part 45 - Plumbing, Batteries and a Little Bit of Fire.

28:46

DIY EV Part 44 - Plumbing and Cabling front to Back?

27:32

DIY EV Part 43 - Fuel Tank Battery Box Installed at last.

24:19

DIY EV Part 42 - More BMS Wiring

23:06

DIY EV Part 41 - Fish tank Battery Box

06:29

DIY EV Power Steering Using a Car Alternator Part 2 - A wee update.

27:13

DIY EV Part 40 - Installing batteries for real this time!

26:46

DIY EV Part 39 - Preparing the 'Good' car for Electrification.

11:21

DIY EV Part 38 - Weighing the car before and after Conversion

28:59

ESP32 Broadcasting Temperature on WiFi Optimised by ChatGPT

44:28

Mercedes Rear Brakes, Disks, Pads AND Shoes

00:18

Wheel spin in 2nd gear. This time with sound. 😝

27:11

DIY EV Part 36 - Connecting up the HV Junction Box Plus a VERY quiet test run.

31:43

DIY EV Part 35 - Rear battery box in the Boot/Trunk

01:16

Fitting a wheel stud without taking the hub apart

14:28

DIY EV Part 34 - 12V Battery Tray

30:49

DIY EV Part 33 - Rear Lower Battery Box

19:38

DIY EV Part 32 - Hacking Away half the Frame Plus New Battery Box

17:36

DIY EV Part 31 Front Battery box cover - Making Complex shapes from Sheet steel using simple tools.

24:19

DIY EV Part 30 - First Drive

22:35

DIY EV Part 29 - Front Battery Box Plus First Drive Preview.

21:15

DIY EV Part 28 - High Voltage Junction Box.

08:20

DIY EV Part 27 - Outlander PHEV OBC Charger Pt2 - ACDC ROCKS!

13:35

DIY EV Part 26 - Outlander PHEV OBC Charger Pt1 Three reasons Why I Failed Before.

00:35

Freddie says wind is scary when you're only wee.

31:15

DIY EV Part 25 - High Voltage Cockups and BMS working in LeafSpy.

34:17

DIY EV Part 24 - Connecting the Nissan Leaf BMS - Did it let out the Blue Smoke?

25:44

DIY EV Part 23 - Making up BMS connections for the Slave modules. Pt2

26:13

Five Massage Guns from Amazon for under £50. Head to Head Test.

26:05

DIY EV Part 22 - Battery Modules BMS wiring Pt1

17:24

Voltage Reference Tester to Calibrate a Multimeter (Accurate? Probably!)

20:53

DIY EV Part 21 - When buying batteries is Expensive BUY MORE!!!

24:34

DIY EV Part 20 Building the Frame for the Inverter

33:04

DIY EV Part 19 - Fuel Tank Battery Box Build and Inverter Positioning

41:32

Alternator Motor Permanent Magnet and Hall sensor Upgrades - It didn't go well! 😞

06:40

Should you buy a Power File and if so which one.

03:16

How to Count the Magnets in an Ebike Hub Motor (Short)

23:47

Why I returned this Dewalt Cordless Angle Grinder

11:08

How to install Arduino Drivers When the Official Method Doesn't Work.

43:04

180A 2500W Alternator Motor Part 2 - SUCCESS!!!

17:41

180A 2500W Alternator Motor Part 1 FAIL!!!

21:50

Monetising YouTube, Affiliate Marketing, Riding in Belfast and Triggering a Speed Camera on my Ebike

29:10

I melted the Phase Wires in my Ebike!! This is how I fixed it.

03:15

Ninja Attack kitten!

23:44

Dewalt DCD996 Cordless Drill Box Opening and First Test.

34:41

Clarke MIG Welder Upgrade Euro Torch and Earth Clamp

14:02

Bafang BBS01, BBS02 and BBSHD Android App for Reprogramming.

29:10

KT Sine Wave Controller on a Voilamart motor + Counting the Magnets in the Motor.

22:21

KT 1500W Sine Wave Ebike Controller Installation.