22:09

Rebuilding a Farmall H or M governor

05:55

Rebuilding a Farmall H hand friction throttle lever

14:03

Converting existing carpet covered stairs to solid oak

07:14

Progress on the Little Genius tail wheel dust cap and spindle.

03:30

Little Genius Tail Wheel Situation

07:19

The start of the IH Little Genius plow restoration.

10:01

Telecaster Restoration for Jeff - before and after

04:00

1960 Tonka Toys Stepside Pickup Truck Restoration - Farmall parts runner

10:53

Improving the trigger pull on a Benjamin / Sheridan C series air rifle to improve accuracy

16:37

Misleading horsepower ratings on power tools

08:04

Making a cheap Grizzly drill press motor start and run better (Part 2)

13:03

Making a cheap Grizzly drill press motor start and run better (Part 1)

03:42

Adjusting the chimes on a Bally pinball machine

10:12

Making a Harbor Freight 4 inch belt sander more useful

06:53

Jointer Knife Sharpening Jig with Actual Results

10:14

Get a 12 inch Disc Sander and make these improvements (if needed)

09:59

Hercules sand paper from Harbor Freight Vs. 3M and Norton

08:18

Preparing to install the engine in Adam's White 2-105 tractor. Part 1

02:35

Engine installed in Adam's White 2-105 tractor. Part 2

03:48

George's IH Little Genius 2 bottom plow

04:37

Whirlpool gas range burner not lighting property - Fixed

03:02

Test running the 5.5 hp electric motor for the Surge vacuum pump

10:12

Inspecting and Rebuilding a 5.5 hp, 230 Volt, Capacitor Start/Capacitor Run, Electric Motor

04:17

Toro 22" Recycler with Tecumseh engine not developing full power

07:14

A helpful tip for keeping the nozzle on Rust-Oleum spray paint cans unplugged

12:04

You can nickel plate in your garage. Part #2 Plating the metal.

16:34

You can nickel plate in your garage. Part #1 Cleaning the metal.

15:46

A lesson on electric motors: Salvaging an electric motor from an oil-less air compressor.

14:10

Upgrade a bench grinder so it starts faster

07:25

Idle jet repair - Farmall H & M carburetor

06:29

How to properly test and repair a brass carburetor float

03:50

LED bulbs for the garage "on the cheap" (part 1)

07:26

10-20 McCormick Deering carburetor - International Harvester

16:56

Why positive ground was used on old cars, trucks and tractors

00:59

Testing a Furnace Hot Surface Ignitor in less than 1 minute.

08:45

Farmall H Fuel Tank Liner Conclusion (Thoughts and Opinions)

05:51

Farmall H Bolster Shaft and Bushing Bearings Installation (part 2 of 2)

15:40

Farmall H Bolster Shaft and Bushing Bearings Installation (Part 1-3/4 of 2)

09:18

George's 1944 Farmall H Restoration

02:38

George's 1944 Farmall H & Start of Gas Tank Relining

06:11

Farmall H Bolster Shaft and Bushing Bearings [Part 2 with corrections]

09:49

Farmall H Bolster Shaft and Bushing Bearings [Part 1]