17:14

Fitting Anderson Powerpole connectors and a LiFePO4 battery for portable/emergency use

01:58

An interface cable that's got my interest

08:55

I put the antennas back on the roof of the car, it wasn't all to plan

02:24

I took my antennas off the car for its MOT and found a problem with the CB antenna

04:15

channel update, why it has been a little quiet on the video front

04:30

I have fixed a high SWR problem on my mobile CB antenna and this is the result

18:06

Voltages of the Sanyo LC7137 synthesiser IC found in 1980s CB radios...

03:22

If APRS is anything to go by, conditions on 2-metres are good right now #hamradio #aprs

38:19

Making another T2LT for potential home base station use

53:01

Thunderpole T-800 2023 version with Public Address feature

08:46

The 2023 Ripon and District Amateur Radio Society Rally

13:03

swapping out igate power supply (unplanned video)

27:52

The 2023 NARSA rally at the Norbreck Castle Hotel, Blackpool

13:31

3D printed adjustment tool for the Cybernet 134 PA inductors

10:28

My old network hardware generated QRM on 2-metres, but the culprit remains a mystery

02:35

calibration and use of SWR meter (request by a subscriber)

02:51

The dead LED in the Thunderpole T-3000

12:04

Fault finding the in-car CB installation

25:23

rewiring my extension speaker to plug into the Yaesu FTM-400XDE directly

06:22

Icom IC F4SR battery pack rebuild dilemma

51:23

A "QRP" loop antenna from AliExpress, unboxing, first look, assembly and tests

10:44

Computer controlled CB, how I did it

07:39

Programming a frequency into the Yaesu FTM-400XDE for 70cm APRS use

01:31

New Year's eve livestream announcement

02:11

Merry Christmas from M0WNU/26CT730

55:38

Radio from places I have lived: 1: Brixham, South Devon (but it didn't go to plan)

02:45

Country modes of the Team RoadCom-FS #cbradio

13:32

Hearing Simon "The Wizard" on the air today #cbradio

26:47

Repairing the CB coaxial cable in the car

01:05:53

Some radios to try and get working, Retevis RT3 & Icom IC-F4SR

00:25

changing a poor quality coupler for a better quality one

11:35

Going on 4-metres with the Motorola GM350 for the first time - just the QSO I made

01:08:27

Going on 4-metres with the Motorola GM350 for the first time

03:12

A lift on CB? Perhaps so, very noisy band conditions

06:13

Motorola GM350 current draw tests

20:48

Hard-wiring the Thunderpole T-3000 in the car

14:45

Plan to potentially hard-wire my Thunderpole T-3000

42:17

My first attempt to access the repeater on board the International Space Station from home

02:40

3D printing a coupler for a beam antenna (timelapse video)

10:59

Attempting to access the ISS repeater from the car

00:58

Thunderpole T-800 on the bench, adjusted up to 4 watts from about 3ish watts

08:02

Testing some PMR446 radios for sensitivity with an inductive coupled signal generator

35:20

Harvard 020 dual range test vs. Intek H-520 plus at the old racecourse in Richmond

02:59

Useful CB repair aids: signal generator, frequency counter and oscilloscope

01:39

Coming up in the next video for release 18th July 2022...

02:57

Uniden Uniace 100 progress update, receiver tuned up and s-meter set up to read correctly

02:45

Uniden Uniace 100 repair update: balanced transmitter and the two dodgy capacitors changed

11:04

useful CB repair aids: the humble multimeter

03:14

Team RoadCom-FS internal presets

02:26

Useful CB repair aids: power meters

02:51

Useful CB repair aids: service manuals

03:19

Useful CB repair aids: microphone wiring diagrams

25:39

SilverCrest PMR446 radios from Lidl

02:39

Inside the Motorola Talkabout T62 and SilverCrest PMR446 radio

03:14

Answering a viewer's comment

03:13

Pod Point EV chargers creating QRM on CB and 10-meters

11:33

The 2022 Durham & District Amateur Radio Society Rally at Bowburn, County Durham

01:50

Uniden Uniace repair update 2

01:04

A couple of my CQ calls on 80-meters received on Hack Green

19:41

The mode jumpers inside the Thunderpole T-600 and PNI Escort HP7120