GR Engineering | Poke

GR Engineering @UC9FhII8Z4j_2WynYNWQLRsQ@youtube.com

2.2K subscribers - no pronouns :c

I recently graduated with a Mechanical Engineering Bachelor'

Videos Posts

Recently Uploaded Popular Oldest

4.20 Figure P4.20 provides steady-state data for water vapor flowing through a piping configuration.

4.4 Air modeled as an ideal gas enters a combustion chamber at 20 lbf/in^2 (psi) and 708°F

4.3 Steam enters a 1.6 cm-diameter pipe at 80 bar and 600°C with a velocity of 150 m/s.

4.2 Refrigerant 134a exits a heat exchanger through 0.75-in diameter tubing with a mass flow rate

4.1 A laser Doppler velocimeter measures a velocity of 8 m/s as water flows in an open channel.

6.79 Air enters a turbine operating at steady state at 8 bar, 1400 K and expands to 0.8 bar.

4.16 Air enters a one-inlet, one-exit control volume at 6 bar, 500 K, and 30 m/s

4.55 Refrigerant 134a enters a compressor operating at steady state as saturated vapor.

4.19 As shown in Fig. P4.19, steam at 80 bar, 4408°C, enters a turbine operating at steady state.

4.5 Air exits a turbine at 200 kPa and 1508°C with a volumetric flow rate of 7000 liters/s.

4.8 Figure P4.8 shows a mixing tank initially containing 2000 lb of liquid water.

4.48 Steam enters a turbine operating at steady state at 2 MPa, 360C with a velocity of 100 m/s.

4.80 Steam enters a counterflow heat exchanger operating at steady state at 0.07 MPa.

Air is compressed at a steady state from 1 bar, 300 K, to 6 bar with a mass flow rate of 4kg/s.

Water is in an expandable container that maintains mechanical equilibrium with the atmosphere.

Three steam lines enter a collection tank operating at steady state.

Carbon dioxide is sealed in a piston-cylinder system. The initial volume of CO2 is 0.1 m^3.

The specific volume of water contained in a tank at 200 psi is 1.5 ft3/lbm.

A gas inside a piston-cylinder assembly undergoes the following sequence of processes:

A piston-cylinder assembly contains 1.5 lbm of gas undergoing a thermodynamic process 1 to 2.

Using the method of joints, determine the type of force in member ‘AD’ of the below shown truss.

If θ (theta) = 60° (degrees), and F = 450 N, determine the magnitude of the resultant force